Finished wiring of the prototype, hooked it up

So I finished cabling up the solderless breadboard, and after checking connections, and checking pwr and gnd, I plugged it into the amiga.

The amiga boots, which is a good sign, but then it never recognizes the memory.  I’m not sure why yet, but I’m working on it.

Time to “work on” some sleep.

 

About the author

keith

Amateur Electronics Design Engineer and Hacker

One Comment

  • Turns out that I was off-by-one-pin on some wires that plug into the breadboard. This included /OE not being wired correctly to ground….. This could possibly have been the key.

    I now show 32.5 ohms between power and ground. I’m not sure if this is a problem or not. It’s clearly not a dead short.

    I need to do more testing and double-checking before I fire it back up again.